Compression Springs
Springmakers manufacture a wide a variety of compression springs to our customers' exact specific requirements. Our full design and prototyping service allows the time between initial conception to working product to take only a matter of hours.
Available in straight, conical or barrel shaped with plain or ground ends, we can produce compression springs using wire sizes ranging from 0.5mm to 19.05, in round or section-type wire. Tolerances are maintained to the correct British Standard i.e. BS1726 Part 1 (2002) Grade 2 unless otherwise requested.
Compression Springs:
- Carbon Steel
- Stainless Steel
- Silicon Chrome
- Chrome Vanadium
- Phosphor Bronze
- Various grades of alloy steels including Inconel and Nimonic
Various plating and finishes can be applied to improve resistance to adverse environments:
- Zinc Plate (Yellow/silver etc)
- Nylon Coatings (e.g. Xylan)
- Delta Tone/Seal
- Powder-coating in any colour
- Light Oil Coating
Request a compression springs quote...
For Quotation purposes it will helpful to provide the following information (If a pre-existing design is available; if not just supply us with a brief description of its function and working environment to aid design):
- Material type and size
- Outside/Inside diameter
- Free Length
- Number of coils and end configuration (Open ends, Closed ends, Ground, Un-ground)
- Spring rate/ Load at pre-determined length
To discuss your compression spring requirements please telephone 01594 825 928
Outside office hours please email your request through using our contact Springmakers Redditch form.
Compression Springs
Compression Springs: